Then proceed with UniPST and the RIM DLL to edit the registration ID (and List) to '2004'Ĭatatan:::bb nya harus udah unlcok yah. NOTE: If PRL reverts (SPRINT), use QXDM command to read and disable NAM_LOCK:Ī) nv_read nam_lock (should read enabled, which we'll change in the next command) #6digitMSL and SEND to start NAM Programming Optional: use this command to change code to zeros or another 6 digits.ĩ) Finally, through the phone type #4357* (#HELP*) to verify the PRL write.

If needed change file path to location of PRL. Turns radio off and sets to service mode. I recommend setting the GATHER TEXT feature to 6 succession, only numbers and have Unicode characters tolerated.Ħ) Once you obtain the SPC/MSL, exit UniCDMA and run QXDM.ħ) Configure QPST (globe in system tray) and QXDM to the correct ports, phone must show detected.Ĩ) Using QXDM (ensure VIEW is set to COMMAND OUTPUT) type the following commands: Users are unaware of the service degradation caused by handovers. d) Minimum LTE to UMTS/GSM handover delay is guaranteed. Use this tool to filter out unnecessary characters. c) Parameters are correctly set to improve the IRAT handover success rate, lower the impact of a handover on the service, and prevent ping-pong handovers. Pertama.gw copas aja dari forum sebelah yah.ġ) Install QXDM (2.08 Release Recommended)Ģ) Install Blackberry Desktop Manager (Should create two RIM Virtual Ports on PC)ģ) Run Blackberry Desktop Manager the entire time (Device should show connected)Ĥ) Using UniCDMA read MSL/SPC from the following:ĥ) With WinHex (or equivalent HEX Editor) search for 6-digit code in the memory dump by using the GATHER TEXT feature in the SPECIALIST menu. Pertama cari dulu softwer qpst n qxdm nya Cara menampilkan settingan blackberry cdma

Qxdm mode offline